Many customer wonder why hydrostatic level sensors fail because of lightning strikes, even though they ordered a level sensor with integrated lightning protection. Focusing on how the lightning protection works and how lightning strikes affect hydrostatic level sensors is important in resolving this confusion.
When Exactly , a special type of hydrostatic level sensors, were first installed into reservoirs and lakes to monitor level, the sensor would become burned or destroyed following a lightning storm or inclement weather periods. This prompted much research into the aftereffect of lightning storms on the instrumentation in reservoirs and the cabling to and from the website.
What lightning protection really means
The first thing to understand is that the effect of a lightning strike is considerably different based on how near to the pressure sensor the lightning strikes into the ground or installation. It really is fair to state that no level sensor will survive a direct or very close nearby lightning strike, where often the whole cabin including all installed electronics will be incinerated by direct hits.
However, more distant hits will only improve the Voltage differential by for instance 1500 Volts. In case a local lightning strike raises the electric potential of a reservoir, the particular level sensor may provide the shortest method for the raised voltage and current to earth. The power will then dissipate into the ground via the level probe and thus destroy or damage its electronics. This might equally function as case when overhead wires take a hit.
How does lightning protection in level sensors work?
However, sensors can be protected from these lightning strikes by installing or integrating a transient voltage protection in to the hydrostatic level sensor. Due to the short nature of the voltage pulse, an element may be suited to or integrated into the sensor that acts on rising differences in voltage potential. If the voltage goes above say 50 Volts, this lightning protection can short-circuit the electronic circuit to ground, allowing a way to ground for the surge and protecting the electronics around the utmost specified voltage potential.
The component would normally operate in a non-conductive state, but will be conductive for a voltage transient, allowing the voltage spike to flow harmlessly to ground. If the bond to earth is not good enough or no lightning protection is integrated within the hydrostatic level sensor, then your electronics will take the entire level of energy of the voltage pulse and fail.Therefore the protection is only as effective as the earth grounding supplied by the user.
In outdoor applications, where submersible pressure transmitters are generally used, WIKA provides an optionally integrated lightning protection inside the level sensors. The sensor electronics will then be protected from local power surges and transient high voltage. Lightning protection is a combination of protection within the instrument and a good low impedance earth grounding.
Check out the profiles of WIKAs submersible pressure transmitters LH-20 and LH-10.
Please use our contact form if you want further assistance.
Please find further information on this topic on our information platform ?Hydrostatic level measurement?